Adjustment of warp tension of let-off mechanism
For mechanical let-off, the warp tension is set by the weight and position of the weight on the weight arm. The specific steps are as follows:
1. Calculation of the tension on the machine
According to the variety and specifications of the fabric, follow the following Formula to calculate the total tension of warp yarns:
In the formula: T——Total tension of warp yarns (kg);
K——Tension per denier (g/denier);
Tt——Spinning yarn density (tex);
D1——Warp denier number;
N——Total number of warp yarns.
Among them, the selection of K value changes according to the type of warp yarn and the finishing method. Generally, the selection can be made by referring to Table 3-2.
2. Selection of the position of the heavy hammer
(1) The computing of the upper formula, the total tension of the scriptures is 130kg.
(2) Draw a horizontal line T at the 130kg position in Figure 3-20.
(3) The intersection point of T and the weight line of the weight is the weight of the weight 3.25kg.
(4) The intersection of T and the oblique line extends downward to the hanging position of the weight. If it is not an integer, take the closest position.
The relationship between tension and weight shown in Figure 3-18 is only a theoretical calculation value and can only be used as a reference. It should actually be done after the loom is put into operation, depending on its operation conditions.
For electronic let-off, the upper machine tension is pre-set through the operation panel. It is also possible to set relevant parameters so that the warp tension when starting is completely consistent with the tension when parking, and by controlling the position of the cloth mouth, it is possible to prevent the occurrence of parking stalls.
AAAFYYTRUYJY76I
Extendedreading:https://www.yingjietex.com/product/FULL-DULL-NC-TWILL-Fabric.html
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedread
